Tasks
Maintenance work generated from requests and future preventive rules.
Active Work
Open, in-progress, and review-state work that still needs attention.
Steer 50 was shut down due to a vacuum pump overheating error.
Dispatch maintenance team immediately to inspect and repair/replace the vacuum pump. Check for any related system issues that could cause recurrent overheating. Restore producti...
Gearbox: Check gearbox oil level and condition
Check gearbox oil level and condition Schedule: every 500 hours.
Extruder: Never operate without installation of a protection device against the
Never operate without installation of a protection device against the melt pressure rising above the maximum level. Schedule: triggered by condition-based.
Feeder calibration: Check feeder calibration and dosing accuracy
Check feeder calibration and dosing accuracy Schedule: every 1 month.
Extruder: Never operate without installation of a protection device against the
Never operate without installation of a protection device against the melt pressure rising above the maximum level. Schedule: triggered by condition-based.
The material is not coming out, and it seems that the screw got damaged. Need...
Immediately send a qualified maintenance technician to inspect and replace or repair the damaged screw on the affected machine. Check for possible further internal damage and en...
Hydraulic leak near injection unit. Oil is dripping under the extruder and op...
Immediate shutdown of affected equipment, isolate leak, deploy spill containment, and assign maintenance technician to repair hydraulic line and inspect for further damage.
Hydraulic oil is leaking under the extruder. Operators noticed pressure fluct...
Inspect immediately and stop operation until the issue is assessed.
Hydraulic leak near injection unit. Oil is dripping under the extruder and op...
Inspect immediately and stop operation until the issue is assessed.
Hydraulic leak near injection unit
Inspect immediately and stop operation until the issue is assessed.
Closed / False Alarm History
Completed, cancelled, rejected, and false-alarm tasks kept for audit history.
Show closed history
Vacuum and venting system: Inspect vacuum venting line, seals, and filter condit
Inspect vacuum venting line, seals, and filter condition Schedule: every 250 hours.
not rotating
Immediate investigation and repair of the equipment to restore rotation and resume production.
Vacuum and venting system: Inspect vacuum venting line, seals, and filter condit
Inspect vacuum venting line, seals, and filter condition Schedule: every 250 hours.
The pelletizer and classifier need to be cleaned, and the cutters require sha...
Schedule cleaning of the pelletizer and classifier as well as sharpening of the cutters at the next available planned downtime. Ensure cleaning and sharpening are completed befo...
No maintenance issue described.
No action required. This task was marked as a false alarm or non-maintenance item.
This is a test email. No maintenance issue described.
No action required. This task was marked as a false alarm or non-maintenance item.
Pelletizer cutters on the Steer Mega 50 may not be sharp enough, affecting th...
Schedule immediate inspection and sharpening or replacement of pelletizer cutters to prevent further quality deviation.
Feeder calibration: Check feeder calibration and dosing accuracy
Check feeder calibration and dosing accuracy Schedule: every 1 month.
Extruder: Never operate without installation of a protection device against the
Never operate without installation of a protection device against the melt pressure rising above the maximum level. Schedule: triggered by condition-based.
Vacuum and venting system - Inspect vacuum venting line, seals, and filter condition
Inspect vacuum venting line, seals, and filter condition
Gearbox - Check gearbox oil level and condition
Check gearbox oil level and condition