Hydraulic leak near injection unit. Oil is dripping under the extruder and op...
Request-based corrective task
Immediate shutdown of affected equipment, isolate leak, deploy spill containment, and assign maintenance technician to repair hydraulic line and inspect for further damage.
Complete Task
Record the actual work performed before closing the task.
Edit Task
Human review can correct the machine, priority, status, due date, action, and notes.
Original Request
One-time issue that generated this corrective task.
Hydraulic leak near injection unit. Oil is dripping under the extruder and operators report pressure fluctuation.
- Issue Type
- Hydraulic system leak at injection unit
- Production
- Production stopped due to hydraulic failure and pressure fluctuation.
- Safety
- High—oil spill and potential for slips or equipment damage, risk of hydraulic system failure.
- Quality
- High—pressure fluctuation leading to defective parts.
Completion Log
Human completion record for this one-time task.
No completion logs recorded yet.
Machine Maintenance History
Other maintenance tasks on this machine for context around this one-time issue.
Steer 50 was shut down due to a vacuum pump overheating error.
Record technician assigned, inspection result, root cause, parts replaced, downtime, and final operating condition. Confirm line restart time and production impact before closing. Manager review recommended before marking complete.
Extruder: Never operate without installation of a protection device against the
This prevents catastrophic failure or risk to personnel from overpressure events. Periodically verify the device is installed and functional.
No maintenance issue described.
Cancelled during human review because this item should not be treated as active maintenance work.
This is a test email. No maintenance issue described.
Cancelled during human review because this item should not be treated as active maintenance work.
Pelletizer cutters on the Steer Mega 50 may not be sharp enough, affecting th...
Schedule immediate inspection and sharpening or replacement of pelletizer cutters to prevent further quality deviation. Parts replaced: cutters Notes: The cutters can be resharpened upon the operator's request.
Extruder: Never operate without installation of a protection device against the
Never operate without installation of a protection device against the melt pressure rising above the maximum level. Schedule: triggered by condition-based. Notes: This prevents catastrophic failure or risk to personnel from overpressure events. Periodically verify the device is installed and functional.
Extruder: Never operate without installation of a protection device against the
This prevents catastrophic failure or risk to personnel from overpressure events. Periodically verify the device is installed and functional.
Hydraulic oil is leaking under the extruder. Operators noticed pressure fluct...
Inspect immediately and stop operation until the issue is assessed.
Hydraulic leak near injection unit. Oil is dripping under the extruder and op...
Inspect immediately and stop operation until the issue is assessed.
Hydraulic leak near injection unit
Inspect immediately and stop operation until the issue is assessed.