Steer 50 was shut down due to a vacuum pump overheating error.
Request-based corrective task
Dispatch maintenance team immediately to inspect and repair/replace the vacuum pump. Check for any related system issues that could cause recurrent overheating. Restore production as soon as safely possible.
Complete Task
Record the actual work performed before closing the task.
Edit Task
Human review can correct the machine, priority, status, due date, action, and notes.
Original Request
One-time issue that generated this corrective task.
Steer 50 was shut down due to a vacuum pump overheating error.
- Issue Type
- Vacuum pump overheating and equipment shutdown
- Production
- Steer 50 is stopped—production halted on this line.
- Safety
- No immediate safety risk indicated by the report.
- Quality
- No current quality risk; however, extended downtime could cause scheduling issues.
Completion Log
Human completion record for this one-time task.
No completion logs recorded yet.
Machine Maintenance History
Other maintenance tasks on this machine for context around this one-time issue.
Extruder: Never operate without installation of a protection device against the
This prevents catastrophic failure or risk to personnel from overpressure events. Periodically verify the device is installed and functional.
No maintenance issue described.
Cancelled during human review because this item should not be treated as active maintenance work.
This is a test email. No maintenance issue described.
Cancelled during human review because this item should not be treated as active maintenance work.
Pelletizer cutters on the Steer Mega 50 may not be sharp enough, affecting th...
Schedule immediate inspection and sharpening or replacement of pelletizer cutters to prevent further quality deviation. Parts replaced: cutters Notes: The cutters can be resharpened upon the operator's request.
Extruder: Never operate without installation of a protection device against the
Never operate without installation of a protection device against the melt pressure rising above the maximum level. Schedule: triggered by condition-based. Notes: This prevents catastrophic failure or risk to personnel from overpressure events. Periodically verify the device is installed and functional.
Extruder: Never operate without installation of a protection device against the
This prevents catastrophic failure or risk to personnel from overpressure events. Periodically verify the device is installed and functional.
Hydraulic leak near injection unit. Oil is dripping under the extruder and op...
Immediate shutdown of affected equipment, isolate leak, deploy spill containment, and assign maintenance technician to repair hydraulic line and inspect for further damage.
Hydraulic oil is leaking under the extruder. Operators noticed pressure fluct...
Inspect immediately and stop operation until the issue is assessed.
Hydraulic leak near injection unit. Oil is dripping under the extruder and op...
Inspect immediately and stop operation until the issue is assessed.
Hydraulic leak near injection unit
Inspect immediately and stop operation until the issue is assessed.